Solar · 2 min read

Solar charging explained: panels, watts and real-world speed

What a panel's watt rating means, why real output is lower, how cold raises panel voltage, and how to estimate recharge time.

Published Nov 4, 2026 · Last reviewed Nov 4, 2026

Folding solar panel connected to a portable power station in direct sun
Illustration (AI-generated). Not a photo of a tested product.

What the watt rating means

Panel wattage is rated under Standard Test Conditions (STC): 1,000 W/m² of sunlight at a 25 °C cell temperature. NREL reports compare outdoor module performance against these STC datasheet values, and find that real results differ because of temperature, spectrum, soiling and manufacturing tolerances.

Why real output is lower

Panels get hot in the sun, and power falls as temperature rises. An NREL presentation on cell temperature uses a power coefficient of 0.5% per °C for the modules it studied. On that basis, cells running at 45 °C, 20 °C above STC, would lose about 10%: a 200 W panel would make about 180 W before any shading, angle or haze losses. Many modern panels list a smaller coefficient; use your panel's datasheet value.

Real sunlight is also often below 1,000 W/m². The NOCT rating used in the industry assumes 800 W/m², which is why it is lower than the STC rating on the same panel.

Match the input limits

Every station lists a maximum solar input in watts and an input voltage window. Extra panel wattage above the input limit is simply not used. In our database, maximum solar input ranges from 100 W (Anker SOLIX C300) to 2,600 W (EcoFlow DELTA Pro 3).

Cold weather raises panel voltage

A panel's open-circuit voltage (Voc) rises as temperature falls below 25 °C. The U.S. electrical code (NEC 690.7) calculates maximum voltage at the lowest expected temperature. An IAEI worked example multiplies a 35 V Voc module by 1.18 at −17 °C to get 41.3 V. Three of those in series would reach about 124 V on a cold morning, so a station with a 60 V input limit could be damaged by a string that looks fine on paper. Check the manual before wiring panels in series.

Estimating recharge time

Lower bound: hours = battery Wh ÷ realistic panel watts reaching the station. Example: a 1,024 Wh EcoFlow DELTA 3 Plus with 400 W of real panel output needs at least 1,024 ÷ 400 = 2.6 hours of strong, steady sun. Charging losses inside the station are not published, so plan for longer, and remember the sun is not at full strength for most of the day.

Before you buy panels

  • Check the station's maximum solar watts and its voltage window.
  • Check cold-weather Voc against the voltage limit if you wire panels in series.
  • Expect less than the label: heat, angle and haze all reduce output.
  • Check the connector type the station accepts.

Ready to put numbers on it?

Open the calculator

Sources

  1. Analysis of a Single Year of Performance Data for Thin Film Modules Deployed at NREL and NISE (NREL/TP-5J00-66963). National Renewable Energy Laboratory.
  2. Measuring and Modeling Nominal Operating Cell Temperature (NOCT). National Renewable Energy Laboratory.
  3. AE 868: Temperature and PV Performance Optimization. Penn State College of Engineering.
  4. PV Systems Math: Sample Calculations (J. Wiles). IAEI Magazine.
  5. Power Station Advisor product database (manufacturer specifications, checked Nov 4, 2026). Power Station Advisor.

Related guides

We have not physically tested any product mentioned. Specifications come from manufacturer pages and manuals; calculations are estimates. See our methodology.

← All guides